PGEN: GE Frame 5 limited below Rated Power

[The AList]

==> Automation List post by MOB...
To view or reply to this thread: http://www.control.com/thread/1250257936#1251803298


------------------------------------------------------------------------------------
Re: PGEN: GE Frame 5 limited below Rated Power
------------------------------------------------------------------------------------
To throw some light, I understand that the constants could have been possibly fiddled particularly - speed control droop reference value(%/MW).  Check all values pertaining to primary and secondary curves (TTkn_I, TTkn_m, TTkn_k, TTkn_S & TTkn_C).  check for associating constants to CSRGVTXB & L60GVTC.  Hope you get some help. pen back your findings.
------------------------------------------------------------------------------------


==> A Note from the Sender of this Message...
You are receiving this message because a subscription was entered for your address
for the Control.com Automation List.  To unsubscribe, send an email to us at 
forum at control.com requesting your removal from the subscription list.

This email was sent by: 
Control.com, Nerds in Control, LLC,
116 Brigham Hill Rd., N. Grafton, MA 01536, USA.

Copyright 2009 Nerds in Control, LLC. All rights reserved. 
Privacy and Legal Notices may be viewed at:
http://www.control.com/about.php