HMI: MARK VI Problem with TCI

[The AList]

==> Automation List post by CSA...
To view or reply to this thread: http://www.control.com/thread/1257069484#1257106555


------------------------------------------------------------------------------------
Re: HMI: MARK VI Problem with TCI
------------------------------------------------------------------------------------
You haven't told us when this problem started and what was changed to create this problem.

Are you confident of the connection between the HMI and the Mark VI? Because if you're not getting alarms *AND* data, then it might be the problem with the Ethernet link between the HMI and the Mark VI (through the network switch(es)).

But, we need to know when this problem started and what was going on prior to this problem starting and what has been done to try to troubleshoot the problem.
------------------------------------------------------------------------------------


==> A Note from the Sender of this Message...
You are receiving this message because a subscription was entered for your address
for the Control.com Automation List.  To unsubscribe, send an email to us at 
forum at control.com requesting your removal from the subscription list.

This email was sent by: 
Control.com, Nerds in Control, LLC,
116 Brigham Hill Rd., N. Grafton, MA 01536, USA.

Copyright 2009 Nerds in Control, LLC. All rights reserved. 
Privacy and Legal Notices may be viewed at:
http://www.control.com/about.php