COMM: Modbus TCP/ IP to GE Fanuc 90-30

[The AList]

==> Automation List post by Pick...
To view or reply to this thread: http://www.control.com/thread/1257086616


------------------------------------------------------------------------------------
COMM:  Modbus TCP/ IP to GE Fanuc 90-30
------------------------------------------------------------------------------------
When using ModScan to poll the 9030 30xxx or 40xxx registers, any address greater than 30032 or 40032 returns an exception error. It will read 32 words starting at 30001 or 40001, but will not read anything above 30032 or 40032 even at a word length of 1. I know there is an offset between standard Modbus and GEF addressing. The DFS equipment needs standard Modbus addressing. Any thoughts?
------------------------------------------------------------------------------------


==> A Note from the Sender of this Message...
You are receiving this message because a subscription was entered for your address
for the Control.com Automation List.  To unsubscribe, send an email to us at 
forum at control.com requesting your removal from the subscription list.

This email was sent by: 
Control.com, Nerds in Control, LLC,
116 Brigham Hill Rd., N. Grafton, MA 01536, USA.

Copyright 2009 Nerds in Control, LLC. All rights reserved. 
Privacy and Legal Notices may be viewed at:
http://www.control.com/about.php