COMM: Communication using CP341 as Modbus master with 4 slaves

Thu May 28 07:54:59 EDT 2009

==> Automation List post by Eaman...
To view or reply to this thread: http://www.control.com/thread/1026244920#1243509889

------------------------------------------------------------------------------------
Re: COMM: Communication using CP341 as Modbus master with 4 slaves
------------------------------------------------------------------------------------
Dear Daniel

> I have also the sma error but it the CP341 does not receive any data. <

I have same problem. connceting two individual device even with one common cable is ok but I do not know how could I access their register in one program. Do you have any sample program for it?

Thank in you in advance for ypur help.

simco_110 [at] yahoo [dot] com
Best regards
Eaman
------------------------------------------------------------------------------------

==> A Note from the Sender of this Message...
You are receiving this message because a subscription was entered for your address
for the Control.com Automation List.  To unsubscribe, send an email to us at 
forum at control.com requesting your removal from the subscription list.

This email was sent by: 
Control.com, Nerds in Control, LLC,
116 Brigham Hill Rd., N. Grafton, MA 01536, USA.