APPS: PROVOX upgrade

[The AList]

==> Automation List post by J.D. Wheelis...
To view or reply to this thread: http://www.control.com/thread/1234461549#1238433185


------------------------------------------------------------------------------------
Re: APPS: PROVOX upgrade
------------------------------------------------------------------------------------
The decision between using FlexConnect or the DeltaV Controller for PROVOX I/O would reduce to:
1.  Timing of the costs
2.  Age of the installed PROVOX I/O

1.  The DeltaV Controller for PROVOX I/O will allow the delay of the replacement of the PROVOX I/O until a later date, which has been shown to be cost-effective in justification calculations.

2.  If the PROVOX I/O currently installed is the older MUX I/O, you may prefer to utilize FlexConnect or a different available solution.

I can discuss in-depth, if you wish to contact me.

Regards,

J.D. Wheelis, Modernization Consultant
------------------------------------------------------------------------------------


==> A Note from the Sender of this Message...
You are receiving this message because a subscription was entered for your address
for the Control.com Automation List.  To unsubscribe, send an email to us at 
forum at control.com requesting your removal from the subscription list.

This email was sent by: 
Control.com, Control Technology Corporation,
25 South Street, Hopkinton, MA, 01748, USA.

Copyright 2009 Control Technology Corporation. All rights reserved. 
Privacy and Legal Notices may be viewed at:
http://www.control.com/about.php