PGEN: Mark IV vibration control constant calculation

[The AList]

==> Automation List post by CSA...
To view or reply to this thread: http://www.control.com/thread/1235979122#1236025489


------------------------------------------------------------------------------------
Re: PGEN: Mark IV vibration control constant calculation
------------------------------------------------------------------------------------
The method for handling different sensitivities changed during the product life of the Mark IV. It wasn't possible on early Mark IV panels; it was difficult at best on later panels.

The Control Specification - System Settings document should provide some information if it's possible on the panel at your site. I think the vibration protection information is covered in Sect. 09 of the Control Specification.

Sometimes, the Control Specification - System Adjustments had some relevant information, also.

Wish the news was better. Perhaps someone reading this post who has a Mark IV with the Control Constant name you listed and with 150 mv/IPS sensors could provide the value of the Control Constant.

------------------------------------------------------------------------------------


==> A Note from the Sender of this Message...
You are receiving this message because a subscription was entered for your address
for the Control.com Automation List.  To unsubscribe, send an email to us at 
forum at control.com requesting your removal from the subscription list.

This email was sent by: 
Control.com, Control Technology Corporation,
25 South Street, Hopkinton, MA, 01748, USA.

Copyright 2009 Control Technology Corporation. All rights reserved. 
Privacy and Legal Notices may be viewed at:
http://www.control.com/about.php