PGEN: Mark Vie hardware versus Mark v or mark vi

[The AList]

==> Automation List post by dinster...
To view or reply to this thread: http://www.control.com/thread/1222923831#1231130653


------------------------------------------------------------------------------------
Re: PGEN: Mark Vie hardware versus Mark v or mark vi
------------------------------------------------------------------------------------
Hi sir,

If you don't mind (I hope you don't)... would you share with us on:

1) Reliability of Mark VIe based on your experience.

2) Total cost for Mark VIe per panel - rough ballpark figure will do - just for our budgeting purposes.

Regards.
------------------------------------------------------------------------------------


==> A Note from the Sender of this Message...
You are receiving this message because a subscription was entered for your address
for the Control.com Automation List.  To unsubscribe, send an email to us at 
forum at control.com requesting your removal from the subscription list.

This email was sent by: 
Control.com, Control Technology Corporation,
25 South Street, Hopkinton, MA, 01748, USA.

Copyright 2009 Control Technology Corporation. All rights reserved. 
Privacy and Legal Notices may be viewed at:
http://www.control.com/about.php