NET: Convert dry contacts + 4-20 mA signals to fiber optic

[The AList]

==> Automation List post by rdodds...
To view or reply to this thread: http://www.control.com/thread/1233668983


------------------------------------------------------------------------------------
NET:  Convert dry contacts + 4-20 mA signals to fiber optic
------------------------------------------------------------------------------------
I need a device (or a system) to convert arround 32 dry contacts + 8 4-20 signals into a fiber optic. The output signal must be based on a DNP 3.0 communication protocol.

Thanks.
------------------------------------------------------------------------------------


==> A Note from the Sender of this Message...
You are receiving this message because a subscription was entered for your address
for the Control.com Automation List.  To unsubscribe, send an email to us at 
forum at control.com requesting your removal from the subscription list.

This email was sent by: 
Control.com, Control Technology Corporation,
25 South Street, Hopkinton, MA, 01748, USA.

Copyright 2009 Control Technology Corporation. All rights reserved. 
Privacy and Legal Notices may be viewed at:
http://www.control.com/about.php