APPS: CNC Bosch Alpha2 question

[The AList]

==> Automation List post by controlfixer...
To view or reply to this thread: http://www.control.com/thread/1026242518#1250320378


------------------------------------------------------------------------------------
Re: APPS: CNC Bosch Alpha2 question
------------------------------------------------------------------------------------
If the machine comes to start the screw-cutting and the axes are in position, which they probably are if ordinary cycles work ok. Then it's the spindle encoder not giving a reference pulse (1 per rev) to synchronize the thread start point, seemples!!
------------------------------------------------------------------------------------


==> A Note from the Sender of this Message...
You are receiving this message because a subscription was entered for your address
for the Control.com Automation List.  To unsubscribe, send an email to us at 
forum at control.com requesting your removal from the subscription list.

This email was sent by: 
Control.com, Nerds in Control, LLC,
116 Brigham Hill Rd., N. Grafton, MA 01536, USA.

Copyright 2009 Nerds in Control, LLC. All rights reserved. 
Privacy and Legal Notices may be viewed at:
http://www.control.com/about.php