PROC: Flow meter with pressure and temp compensation

[The AList]

==> Automation List post by Syukri...
To view or reply to this thread: http://www.control.com/thread/1248382389#1249298111


------------------------------------------------------------------------------------
Re: PROC: Flow meter with pressure and temp compensation
------------------------------------------------------------------------------------
Theoritically if the Pressure and Temperature remain constant, Pressure and Temperature can be neglected but in the nature of gas, Pressure and Temperature will not be constant (effected by environemt and affected by process condition).

Furthermore, Verabar is a Pitot Tube type of Flowmeter which fall under pressure differential type of measurement. So I would say that P&T transmtter is compulsory for the Volumetric Flow measurement.

------------------------------------------------------------------------------------


==> A Note from the Sender of this Message...
You are receiving this message because a subscription was entered for your address
for the Control.com Automation List.  To unsubscribe, send an email to us at 
forum at control.com requesting your removal from the subscription list.

This email was sent by: 
Control.com, Nerds in Control, LLC,
116 Brigham Hill Rd., N. Grafton, MA 01536, USA.

Copyright 2009 Nerds in Control, LLC. All rights reserved. 
Privacy and Legal Notices may be viewed at:
http://www.control.com/about.php