ENGR: When to Use Industrial Motor Frame Grounding

[The AList]

==> Automation List post by Bill Schwarz...
To view or reply to this thread: http://www.control.com/thread/1238448073#1238693057


------------------------------------------------------------------------------------
Re: ENGR: When to Use Industrial Motor Frame Grounding
------------------------------------------------------------------------------------
ANSI/IEEE Standard 141 (Red Book) addresses the necessity of equipment grounding. I also believe that ANSI C2 "National Electric Safety Code" has been adopted by most utilities, so you may want to check that standard.  I am not familiar with it, however.

------------------------------------------------------------------------------------


==> A Note from the Sender of this Message...
You are receiving this message because a subscription was entered for your address
for the Control.com Automation List.  To unsubscribe, send an email to us at 
forum at control.com requesting your removal from the subscription list.

This email was sent by: 
Control.com, Control Technology Corporation,
25 South Street, Hopkinton, MA, 01748, USA.

Copyright 2009 Control Technology Corporation. All rights reserved. 
Privacy and Legal Notices may be viewed at:
http://www.control.com/about.php