COMM: Micrologix 1100 to Yokogawa Centum 3000 DCS via Modbus RTU

[The AList]

==> Automation List post by Gapman...
To view or reply to this thread: http://www.control.com/thread/1238605507


------------------------------------------------------------------------------------
COMM:  Micrologix 1100 to Yokogawa Centum 3000 DCS via Modbus RTU
------------------------------------------------------------------------------------
Do I need to create any code within the Micrologix 1100 to get the data out to the Centum 3000 via Modbus RTU. I have an 1763-NC01 cable connected to Channel 0. If so could you please send me an example table? Thanks
------------------------------------------------------------------------------------


==> A Note from the Sender of this Message...
You are receiving this message because a subscription was entered for your address
for the Control.com Automation List.  To unsubscribe, send an email to us at 
forum at control.com requesting your removal from the subscription list.

This email was sent by: 
Control.com, Control Technology Corporation,
25 South Street, Hopkinton, MA, 01748, USA.

Copyright 2009 Control Technology Corporation. All rights reserved. 
Privacy and Legal Notices may be viewed at:
http://www.control.com/about.php