PROC: Replacement for MK V IDOS computer

[The AList]

==> Automation List post by DAMENE Amar...
To view or reply to this thread: http://www.control.com/thread/1026250273#1223720462


------------------------------------------------------------------------------------
Re: PROC: Replacement for MK V IDOS computer
------------------------------------------------------------------------------------
Hi, Sandy

It is a surprise that actually I am looking at possible replacements for 4 old Texas PCs installed in 1995 with a Mk V TMR for our GE LM2500 GT.

My company decided to upgrade this control system.

Then we are togother face to the same problem.

Our machines are NUOVO PIGNONE equiped by LM2500 Gas Generator. 
All the 4 PCs are at the control room  just 100 m to the machnies.
No remote (PCs) at our station

I need your help, our only problem about the GT LM2500 is their vibration monitoring always indicates zero level.

I need if you can to tell me how your GG LM2500 is protected against vibration  and it is configured.

If I will find any information useful for your case I will to send you all documents but not yet for the moments.

DAMENE Amar
NB :  reply to my email : dameneamar at yahoo.fr

thanks in advance
------------------------------------------------------------------------------------


==> A Note from the Sender of this Message...
You are receiving this message because a subscription was entered for your address
for the Control.com Automation List.  To unsubscribe, send an email to us at 
forum at control.com requesting your removal from the subscription list.

This email was sent by: 
Control.com, Control Technology Corporation,
25 South Street, Hopkinton, MA, 01748, USA.

Copyright 2008 Control Technology Corporation. All rights reserved. 
Privacy and Legal Notices may be viewed at:
http://www.control.com/about.php